Thank you.
Will give it a try now
Really appreciate the help.
Baffled - signals or values
Hi.
No it doesn’t work as it should.
Sometimes it bets as the price goes out through 80.
Sometimes when it goes over 100 but before it drops back to 80
Tried changing LTP to Back price on bet rule.
Tried removing steam to 80 signal so
Stored bsp < 80
Signal > 100 set
Back if 100 signal set and back price < 80.
Still doesn’t work.
Sorry.
No it doesn’t work as it should.
Sometimes it bets as the price goes out through 80.
Sometimes when it goes over 100 but before it drops back to 80
Tried changing LTP to Back price on bet rule.
Tried removing steam to 80 signal so
Stored bsp < 80
Signal > 100 set
Back if 100 signal set and back price < 80.
Still doesn’t work.
Sorry.
I've just looked at it again and can't see any reason for it not to work correctlyValda wrote: ↑Thu Dec 06, 2018 8:10 pmHi.
No it doesn’t work as it should.
Sometimes it bets as the price goes out through 80.
Sometimes when it goes over 100 but before it drops back to 80
Tried changing LTP to Back price on bet rule.
Tried removing steam to 80 signal so
Stored bsp < 80
Signal > 100 set
Back if 100 signal set and back price < 80.
Still doesn’t work.
Sorry.
For all runners with a BSP less than 85 it sets a signal, when one goes above 100 another signal is set, then under 80 a third is set at which point the bet triggers @ 75 if the race has been in-play at least 40 secs.
Betfair always match at the best price so if its gone back above 100 during the 2-sec in-play delay between the bet being triggered and placed there's nothing you can do about that
If you post the log it will confirm if its fired right
i'll run it on the 8:30 myself to double check
Ah ok - according to your log it seems to be working fine.
I was sure I saw bets being placed before the 100 signal should have been set but maybe I’m wrong.
Will give it a good test tomorrow.
Really do appreciate your time and assistance so thanks again.
I was sure I saw bets being placed before the 100 signal should have been set but maybe I’m wrong.
Will give it a good test tomorrow.
Really do appreciate your time and assistance so thanks again.
No probs, as its currently using LTP when setting signals, as you touched on earlier you could change this so signals are set when
back price is > 100
lay price is < 80
that will stop them being set simply due to large gaps between odds and a quick trade above 100 then below 80 occurring
but there still no stopping it from being matched at a higher once all that met, as you can see it was placed at 75 but matched at 90 when it reached the market