Yes, that's correctMIYAGI52 wrote: ↑Mon Nov 20, 2023 5:44 pmHi,
Just after some guidance please.
I want to place a lay bet on the favourite just before the off.
Only if it hasn't steamed in, in the last 2 mins.
So, I've added a condition
Relative Historic Odds Condition
Selection A's (Fav)
Back Price NOW is
greater Than Selection B's (FAV)
2mins ago minus 10 ticks
Is this the right way to stop bet triggering if horse comes in by 10 ticks in the last 2 mins?
Any confirmation would be much appreciated,
Thank you
Miyagi
Back the Steamer Guardian Automation Bot for Horse Racing
-
- Posts: 20
- Joined: Wed Apr 01, 2020 7:58 pm
Hi Dallas or anyone else that wants to answer,
This might seem a dumb question, but would it take much tinkering to get this bot to check the touch price of runners just 20 seconds before the official off time and then again at official off time, and to then back a selection that has a differential of so many ticks due to VERY late money. Then just in-case the bet doesn't get matched to also add the take SP if unmatched rule. Also I would want it to eradicate runners under 3.0 as the tick increments are too low and volatile then. The purpose is, I've noticed in very certain markets there is an extremely late surge of money that can be quite significant. I'd think this would be quite simple to implement? I just find automation very confusing, I've not used it much at all. Thanks for your time.
This might seem a dumb question, but would it take much tinkering to get this bot to check the touch price of runners just 20 seconds before the official off time and then again at official off time, and to then back a selection that has a differential of so many ticks due to VERY late money. Then just in-case the bet doesn't get matched to also add the take SP if unmatched rule. Also I would want it to eradicate runners under 3.0 as the tick increments are too low and volatile then. The purpose is, I've noticed in very certain markets there is an extremely late surge of money that can be quite significant. I'd think this would be quite simple to implement? I just find automation very confusing, I've not used it much at all. Thanks for your time.